Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 34 / 154

xx
Safety Precautions about Transportation
Precautions about Transportation

When transporting this equipment, pack it with specified packing materials.
Also, transport it under appropriate environment condition.
(

Operation Manual "Specification" P14-1)
Monitoring after Power Failure
When the power failure is less than 30 seconds, monitoring will resume with the display mode and patient
information unchanged. When the power failure is 30 seconds or more, monitoring will resume with the default
display mode set by the user, or the display mode which was last set.
HCP-810/HCP-820, HPD-810/HPD-820 will start up from the warm-up mode. The warm-up time differs for each
unit.
To Prepare for Emergency Use
Accessories/Optional Accessories

The ECG electrodes are consumable products. Always prepare extra supplies of electrodes.

Verify that there is no wire break on the patient cable once a week.
Battery Pack

Even if the battery pack is not in use, the remaining capacity decreases due to self-discharge.Make sure to
verify once a week that the battery pack is fully charged.

To fully charge the empty battery pack, it takes 4 hours during operation, and 4 hours when the power is OFF
and AC cable is connected.

The performance of the battery deteriorates with repeated use. To ensure performance of the battery, it is
recommended to replace it once a year.
Electromagnetic Compatibility
The performance of this equipment under electromagnetic environment complies with EN 60601-1-2: 2007.
Do not use any unauthorized equipment or cables as they may not comply with the EMC standard.
CAUTION
CAUTION