Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 122 / 154

6-10
Chapter 6 Setup Item/Default Value Setup Item
NOTE

For the item with *mark, the setting is backed up on the AC Unit (DSA-81). Performing F-
start (turning the power ON with the rotary switch set to F) will not initialize the setting.
The settings may change if the AC Unit (DSA-81) is replaced.

Initial Settings (User Mode Registration: Monitor Mode)
The following settings can be registered for the monitor mode. Other than display configuration setting, the default settings will be applied to all
modes.

Initial Settings (User Mode Registration: Display Configuration)
The following settings can be registered for the display mode. Other than display configuration setting, the default settings will be applied to all
modes.
Item Description Default Backup
Monitor Mode Mode Name 8 characters Adult Mode Yes
Child Mode
Neonate Mode
Initial_Adult
Initial_Child
Initial_Neonate
Patient Classification Manual Printing Settings Auto Printing Settings
Tone/Volume Settings Night Mode Settings Alarm Settings
Settings for Each Parameter
Settings for Review Data (GraphicTrend, Tabular Trend, Recall, OCRG, ST, Zoom Wave, Full Disc. Wave)
Item Description Default Backup
Display Mode Mode Name 8 characters Display 1 Yes
Display 2
Display 3
Display 3
Display 4
Display 5
Display Configuration Color Settings Brightness Settings
Display Mode 1
Item Default Backup
Label Display 1 Yes
Layout Standard/1 Column
Numeric Data HR, SpO
2
, NIBP, RR_IMP
Waveform ECG1, SpO
2
, RESP
User Key Alarm Silence, Display, Alarm (Basic), NIBP Auto Mode,
Monitor Suspend, Full Disc. Wave
Short Trend OFF
15 min.