Fujitsu PRIMEPOWER900, Manual

Page: 84 / 177

54 U41290-J-Z816-3-76
CHAPTER 5 Main Unit Operator Panel
• Symbol and command lists
On the operator panel, select an operation from the symbol menu by pressing the
Cursor switch, and then execute the selected operation by pressing the Decision
switch.
Table 5.2 lists the meanings of the operation menu symbols on the operator panel.
Table 5.3 lists the commands used for the panel operation. These commands are used
for selected partitions (symbols: 0 to e).
For details on commands to select a partition, see Section 5.3.4, "System operation
(symbol 0)."
Each command issued to select a partition is enabled or disabled depending on the
state of the mode switch. For details, see Table 5.4 .
Table 5.2 Meanings of operation menu symbols on operator panel
Symbol Indication Explanation Remarks
T Temperature Temperature of the air intake
section of the main unit
-
Z AC input status Status of the AC input section
AC input status is displayed for
each AC input source.
-
* Abnormal status
(error) An error occurred in the main
unit This symbol is only displayed if
an error is detected.
6
Partition number
selection Symbol used to select the
partition in which system
operation is to be executed When a partition is selected, the
message display area displays the
System operation menu
(including system reset, OS
dump, and partition startup
commands).
0 Partition selection Display of partition number of
selected partition
Note that setting commands should only be performed by a certified service engineer.