Fujitsu ETERNUS CS800, User Manual

Page: 470 / 604

16.1 ETERNUS CS800 S6 Hardware
l
Pull the cable clamp up (2).
l
Thread the power cord through the cable clamp (1).
l
Press the cable clamp down until it engages to secure the cable (3).
16.1.1 Hard Disk Drive
The hard disk drives which can be ordered for the ETERNUS CS800 server are supplied
already mounted in an installation frame so that defective hard disk drives can be replaced
during operation. The hard disk drive and installation frame together make up the HDD
module.
The Hard Disk Drive (HDD) used in the ETERNUS CS800 server is a 2.5" SAS hard disk
(10,000 rpm) and 2.5" SATA hard disks (7,200 rpm).
Handling Hard Disk Drives and HDD Modules
Hard disk drives incorporated in the HDD modules are highly sensitive electromagnetic
devices and must be handled with great care. Incorrect handling can cause partial or total
failure of the hard disk drives. These failures can result in data errors and to a loss of data or
to total corruption of the hard disk drive.
Observe the following rules to prevent such problems occurring:
l
Only store and transport HDD modules within the limits stipulated in the specification.
l
When transporting HDD modules (even over short distances), always use the original
packaging (ESD label).
l
Never expose HDD modules to a temperature shock. Avoid the formation of
condensation inside and on the outside of the hard disk drive.
CAUTION!
The HDD module must be acclimatized in its operating environment for an
acclimatization time before it is started up for the first time.
470 ETERNUS CS800