Fujitsu ETERNUS CS800, User Manual

Page: 465 / 604

15.2.4 Replication Problems
The table below describes corrective actions for problems occurring with the replication.
Priority Level Description
The replication was
paused, but the
replication is still in
process. When you click Pause , the system will continue to replicate the
current tag or block of information in process. The process of
completing the current tag replication can take up to 15 minutes to
complete. Once that tag has completed replication the system will
pause and wait to resume.
The replication was
paused and a
Failure event was
generated in the
Replication Events
page.
This is normal. When a replication is paused, a failure event is
generated on the
Replication Events page. They system will
continue the replication when you click Resume .
Replication was
disabled while a
replication was in
process and the
replication
completed. If you click Disable during a replication in process, the system will
complete the entire replication and then disable replication on the
system. The system will be unable to replicate until you click
Enable .
Enabled replication
on a NAS share and
received the
following Event:
No
destination host
is specified for
replication.
You must configure the target system prior to configuring the source.
If the target system is not configured first, you will not be able to
designate the replication target.
Able to enable and
schedule replication
for NAS even though
no target IP
configured. It is possible to enable and schedule a replication when a target
system has not been configured. The replication will not start until a
target system is configured.
Table 27: Replication Problems
ETERNUS CS800 465
15 Troubleshooting