Fresenius Medical Care 5008, Service Manual

Page: 23 / 168

Chapter 4: Installation
Fresenius Medical Care 5008 SM 1/08.04 4-1
4 Installation
4.1 Preface
Instructions for all technicians who are authorized to commission
our hemodialysis systems.
We, as manufacturers, permanently aim at delivering systems of
highest quality.
To reach this aim, we need your support.
Please commission our hemodialysis systems by uniformly using the
enclosed "initial start-up report" and enter the values determined in the
columns provided.
The following is applicable:
Corrections are necessary only if the measured values are outside
of the tolerances specified!
We will then evaluate the initial start-up reports, which will enable us to
monitor the quality of our systems on their delivery.
After initial start-up, please asap send – by mail or by fax – the
completed form (Initial Start-Up Report) back to the following address:
Fresenius Medical Care
Deutschland GmbH
Werk Schweinfurt
Herrn Alfred Laus, Abt. BM
Hafenstraße 9
97424 Schweinfurt
Fax: 09721/ 678450
Thank you very much for your help!
4.2 Important Information on Initial Start-Up
This technical document is intended for initial start-up only. It is not
intended for restarting hemodialysis systems that have been shut down
or have been put out of service temporarily.
The initial start-up must be performed by the Technical Service of
Fresenius Medical Care or a person authorized by them!
Any information on initial start-up and the specifications in the Operating
Instructions must be observed.
When bringing the hemodialysis system from a cooler to a warmer
room, allow approx. 2 hours for the system to adjust to the ambient
temperature before turning the unit on.