Fresenius Medical Care 5008, Service Manual

Page: 25 / 168

Chapter 4: Installation
Fresenius Medical Care 5008 SM 1/08.04 4-3
No. Description Measure-
ment
value
1 Preparation
1.1 Hemodialysis system without visible shipping damage.
T
1.2 Remove the transport protection for the monitor support arm.
T
Install the IV pole.
T
1.3 Connect the water supply tubing.
T
Connect the drain and the flush tubings.
T
Protect the tubings from slipping out.
T
Standard: Length 3 m, internal diameter 6 mm
Tubing dimensions, adjusted: Length _____ m, internal diameter_____ mm
T
1.4 Connect the CDS tubings and protect them from slipping out.
Apply a shrink tube marking for the CDS tubings.
T
CDS 1
T
CDS 2
T
BIC
T
1.5 Remove the shipping plugs from the overflows.
T
1.6 When turning the hemodialysis system on, perform an audible check of the watchdog alarm.
T
1.7 Rinse out the anti-freeze.
T
1.8 Select the Filter change program.
Connect the filter. DIASAFE
®
plus /ONLINE plus ™
In the service mode, delete mandatory disinfection.
Then completely run the rinse program.
T
2 SETUP settings (Technician's SETUP/Operator SETUP)
2.1 Check the SETUP on the hemodialysis system.
T
3 Check – water inlet flow / adjustment – degassing
3.1 Check MaxWaterFlow.
Desired value: 1300 ml/min to 1550 ml/min ________ Corr.:
T
Yes
T
No
3.2 Perform the degassing adjustment.
T
4 Check – dialysate flow
4.1 Check flow at 800 ml/min.
Desired value: 770 ml/min to 830 ml/min ________
T