FreeWave FGR2-IO-IOE, User Manual And Reference Manual

Page: 6 / 131

2.8 Setting I/O Master Wire Replacement Parameters 41
2.8.1 Default Delay 41
2.8.2 Default Output 42
2.8.3 Mapping I/O Master Outputs to I/O Slave Inputs 42
Map I/O Master Outputs to I/O Slave Inputs in Tool Suite 43
Map I/O Master Outputs to I/O Slave Inputs in the Terminal Interface 43
2.8.4 Sensor Power 44
3. Configuring an I/O Slave 47
3.1 Configuring an I/O Slave 48
3.2 I/O Slaves in Tool Suite 50
3.3 Setting the I/O Slave's Role in the Network 50
3.4 Establishing Communication with the I/O Master 51
3.5 I/O Slave RF Transmission Characteristics 51
3.6 I/O Slave MultiPoint Parameters 51
3.7 I/O Slave Wire Replacement Parameters 52
3.7.1 Digital Output 1 and Digital Output 2 52
3.7.2 AI1 250 Ohms and AI2 250 Ohms 52
3.7.3 DI1 150 Ohms and DI2 150 Ohms 53
3.7.4 Default Delay 53
3.7.5 Digital Output 1 Default and Digital Output 2 Default 54
3.7.6 DI1 Pullup and DI2 Pullup 54
3.7.7 DO Bi-Stable 55
3.7.8 DO Monostable Time 56
4. Other Radio Settings 57
4.1 Setting Other RF Transmission Characteristics 57
4.1.1 Frequency Zones - 900MHz 57
Enable Frequency Zones in Tool Suite 59
Enable Frequency Zones in the Terminal Interface 59
4.1.2 High Noise 60
4.1.3 Hop Table Size - 900MHz 61
4.1.4 Hop Table Version - 900MHz 61
4.1.5 Low Power Mode 62
4.1.6 MCU Speed 63
4.1.7 Remote LED 64
4.1.8 Retry Timeout 64
4.1.9 RTS to CTS 65
Page 6 of 131 LUM0008AG Rev Sep-2015
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.