Wire Replacement I/O (900 MHz): User Manual and Reference Guide
Retry Timeout
Setting
Description
l
When the serial network Master comes back up, the I/O Master breaks
the link with the Slave to re-establish a link with the serial network
Master.
l
After the I/O Master is linked to the serial network Master, then the I/O
Slave are able to link back to the I/O Master.
l
With a lower
Retry Timeout
setting, the I/O Master is more likely to
drop the link to its serial network Master when the incoming signal
becomes poor.
4.1.9 RTS to CTS
Note
: This parameter does not apply in a wire replacement I/O system.
4.1.10 Slave Security
Slave Security
Setting
Description
Default Setting:
(0) On
Options:
(0) On
(1) Off
Terminal Menu:
(3) Edit Transmission Characteristics > (6) Slave Security
Description:
l
In a wire replacement I/O system, leave this parameter set to
On
.
l
A setting of
On
means only the Master listed in the I/O Slave's call book
can link to that slave.
4.1.11 Transmit Power
Transmit Power
Setting
Description
Default Setting:
10
Options:
Any number between 0 and 10.
Terminal Menu:
(3) Edit Transmission Characteristics > (5) RF Xmit Power
Description:
l
Sets the output power of the radio.
l
A setting of 10 is approximately 1 W of output power.
LUM0008AG Rev Sep-2015
Page 65 of 131
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Summary of Contents for FGR2-IO-IOE
Page 131: ......
