Wire Replacement I/O (900 MHz): User Manual and Reference Guide
Data Parity
Setting
Description
Option
Data Bits
Parity
Stop Bits
1
7
Even
1
2
7
Odd
1
3
8
None
2
4
8
Even
1
5
8
Odd
1
2.4.3 Flow Control
Flow Control
Setting
Description
Default Setting:
(0) None
Options:
l
(0) None - No flow control CTS is active and de-asserts when buffering is
98% full. Can pass XON/XOFF data but does not use it in any way.
l
(1) RTS - Uses standard RTS/CTS control lines
l
(2) DTR
Terminal Menu:
(2) Set Baud Rate > (F) FlowControl
Description:
Specifies the hardware flow control for the data port on the radio.
FreeWave Recommends
: Use
Flow Control
if the Baud Rate is
higher than 19200.
2.4.4 Modbus RTU
Note
: When using the radio in
Modbus RTU
mode, the
Master Packet Repeat
setting in the
MultiPoint Parameters tab must match in every radio. The
Modbus RTU
mode must be set to
1
when
radios are configured in RS485 or RS422 mode.
Modbus RTU
Setting
Description
Default Setting:
0 (Disabled)
Options:
0 to 9
Terminal Menu:
(1) Set Baud Rate > (B) Modbus RTU
Description:
A setting other than 0 in this parameter causes the radio to wait for an
LUM0008AG Rev Sep-2015
Page 31 of 131
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Summary of Contents for FGR2-IO-IOE
Page 131: ......
