Wire Replacement I/O (900 MHz): User Manual and Reference Guide
8. Enter the I/O Master's serial numbers in the
Number
column.
Note
: The
Repeater 1
and
Repeater 2
columns remain black as Repeaters are not used in a
wire replacement network.
9. Click the
Transmission Characteristic
tab and set these parameters to the same settings
as the I/O Master:
l
Frequency Key
l
Hop Table Version
l
Hop Table Size
l
Maximum Packet Size
l
Minimum Packet Size
l
RF Data Rate
10. Click the
MultiPoint Parameters
tab and set these parameters to match the I/O Master:
l
Master Packet Repeat
l
Network ID
l
Repeaters
Note
: Subnet IDs are not used in I/O Slaves in a wire replacement network.
11. Click the
Wire Replacement
tab and set these parameters:
l
Digital Out 1 and Digital Out 2
- Mapped to the Digital Inputs of the I/O Master.
Example
: If you select Master DI#1 in the Digital Out 1 field, the I/O Master Digital
Input 1 controls Digital Output 1 on the I/O Slave radio.
l
AI1 250 Ohms and AI2 250 Ohms
- If configuring an FGR2-IOS-CE-U (an enclosed
radio without an expansion port), set the power-up state of the internal resistor 250 Ω
resistor when connecting the I/O Slave's Analog Inputs to an 4-20 mA sensor.
l
DI1 Pullup and DI2 Pullup
- Sets the power-up state of the internal resistor (10
Kohms) connected to the Digital Inputs.
l
They can pull up, such as when using a closed-contact-to-GND switch input, pull
down so that unused inputs read 0 as DIs or ~0 as auxiliary analogs, or float to not
load analog inputs.
l
Digital Out 1 Default and Digital Out 2 Default
- Select the state to which the Digital
Output returns to when the device is powered on or the device loses its link to the I/O
Master in the network.
l
Default Delay
- Enter the amount of time that the I/O Slave waits before entering the
default state defined in
Digital Out 1 Default
and
Digital Out 2 Default
.
LUM0008AG Rev Sep-2015
Page 49 of 131
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Summary of Contents for FGR2-IO-IOE
Page 131: ......
