Wire Replacement I/O (900 MHz): User Manual and Reference Guide
Serial Interface
Setting
Description
l
Turn Off Delay
works as described in all radios.
l
Turn On Delay
works as described on any Slave or Slave/Repeater - it
has no functionality on the Master.
Note
: If set to anything other than
0
, the
Setup Port
parameter on the
Baud Rate
tab must be set to
Diagnostics Only
.
Terminal Menu:
(1) Set Baud Rate > (C) RS232/485
Description:
Use this option to set the protocol of the data port.
2.4.6 Setup Port
Important!
: Do NOT change this setting unless the correct programming cable is available for the new
setting.
Setup Port
Setting
Description
Default Setting:
(3) Both
Options:
l
(1) Main Only - Programming and reading a radio's setup information is
done through the data port.
l
(2) Diagnostics Only - Programming and reading a radio's setup
information is done through the diagnostic port.
l
If the
Serial interface
is set to anything other than RS232, then the
Setup Port
must be set to
Diagnostics Only
.
l
(3) Both - Programming and reading a radio's setup information is done
through either the data port or the diagnostic port .
Terminal Menu:
(1) Set Baud Rate > (D) Setup Port
Description:
Determines which port on the radio, Main or Diagnostics, is used to access
the parameter settings in
Tool Suite
or enter the Setup main menu in the
terminal interface.
2.4.7 Turn Off Delay
Turn Off Delay
Setting
Description
Default Setting:
0
LUM0008AG Rev Sep-2015
Page 33 of 131
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Summary of Contents for FGR2-IO-IOE
Page 131: ......
