4. Other Radio Settings
4.1.7 Remote LED
Note
: This feature is only available on an I/O Master.
Remote LED
Setting
Description
Default Setting:
(0) Local Only
Options
l
(0) Local Only - Only the LEDs on the radio board are enabled.
l
(1) Remote and Local - LEDs on the radio board and remote LEDs through
the diagnostic port are enabled.
l
(2) Remote Only - LEDs on the radio board are disabled. Remote LEDs
through the diagnostic port are enabled.
Terminal Menu:
(3) Edit Radio Transmission Characteristics > (C) Remote LED
Description:
l
If using a radio with the optional 20-pin connector, use this option to
connect remote LEDs through the diagnostics port.
l
By turning off the on-board LEDs (setting = 2) the current consumption
is reduced.
l
To reduce current consumption in Slaves, use
Low Power
(setting =
1
).
l
Remote LED drives the Diagnostic port, which has a small amount of
current draw.
l
When using remote LEDs, the center (TX) LED does not output a signal
for a green LED when in Setup mode.
l
The Green TX LED has no remote pinout.
4.1.8 Retry Timeout
Retry Timeout
Setting
Description
Default Setting:
255
Options:
Any number between 0 and 255.
Terminal Menu:
(3) Edit Transmission Characteristics > (8) Retry Time Out
I/O Slave Setting:
l
By lowering the
Retry Timeout
setting, the inactive link time between the
I/O Master and the I/O Slave can be reduced when going from
autonomous mode to connecting back to the serial radio network.
l
If the serial radio network Master goes down, the I/O Master and I/O
Slave continues to operate in autonomous mode.
Page 64 of 131
LUM0008AG Rev Sep-2015
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Summary of Contents for FGR2-IO-IOE
Page 131: ......