Fluke ScopeMeter 190 Series, Programming Reference Manual

Page: 46 / 120

Page 3.34
=============================================================
QUERY MEASUREMENT QM
-------------------------------------------------------------
Purpose:
Queries for active readings (see Syntax 1) or measurement
results from the ScopeMeter (see Syntax 2).
Command Syntax 1:
QM<cr>
Command Syntax 2:
QM <no>{,<no>}<cr>
where in TrendPlot mode, **************************
<no> = 11 | 21 *
*
where in Meter mode, **************************** *
<no> = 11 | 19 * *
* *
where in Scope mode, ************************** * *
<no> = 11 | 21 | 31 | 41 | * * *
53 | 54 | 55 | 61 | 71 * * *
* * *
<no> MEASUREMENT TYPE / DESCRIPTION * * *
* * *
11 Measurement reading 1 |*| |*|
Meter absolute reading | |*| |
19 Meter relative reading (relative to | |*| |
instrument setup reference value) | | | |
21 Measurement reading 2 |*| |*|
31 Cursor 1 absolute amplitude value |*| | |
41 Cursor 2 absolute amplitude value |*| | |
53 Cursor absolute amplitude value (Maximum) |*| | |
54 Cursor absolute amplitude value (Average) |*| | |
55 Cursor absolute amplitude value (Minimum) |*| | |
61 Cursor relative amplitude value (Delta) |*| | |
71 Cursor relative time value (delta T) |*| | |
Notes: - Maximum 10 readings per command.
- If one of the readings <no> is non-valid, no readings
will be returned.
- Only active (valid) readings will be returned.