FT-10 Fill Technical Manual, Rev. 2.21, July 2020
Page 60 of 131
[
GAT_Ch ]
[ X ]
Gate position check
0 = No gate switch
1 = Gate switch function is enable
Enter gate position check value by pressing
and
keys.
Press the
key to go back to the operation.
Default is “0”.
Note:
For
TARGET
and
TOLERANCE
entry please see section 7, page 69
Mode Related Display Messages
The messages below are shown on the display in the filling cycle or if there is any error in the filling.
Display
Operation
[-
Zero-
]
It is displayed during automatic zeroing before feeding.
[
GAtE
]
It is displayed during gate position control.
[
FuLL
] [ XXXXX ]
This prompt is displayed at the end of Filling by toggling with the
weight value. It disappears when emptying starts.
[
d_dEL
]
Emptying delay time in function.
[
End
]
Bag is full.
[
E ZrnG
] [ XXXXX ]
This error means the weight is out of [
Zero_r
] at the beginning of
Filling cycle. Can be acknowledged by Start input.
[
E ZEro
] [ XXXXX ]
This message appears if zeroing cannot be done at the beginning
of filling because of the zeroing range (par. [
203
]) or unstable load.
It is shown alternately by the weight value.
Applying start input restarts the filling cycle. If this error seen
again, the second start input starts the feeding without zeroing.
[
E GAtE
]
Gate position error.
[
No FEEd
]
Feeding error message appears if weight value is not increased
after feeding output is activated. Refer to parameter [
508
[
FıLL t
]
This prompt announces that the filling is not finished in the filling
time and is ended. Error is cancelled by Reset input. Refer to
parameter [
509
].
