FT-10 Fill Technical Manual, Rev. 2.21, July 2020
Page 69 of 131
7. F
ILLING
T
ARGET AND
P
RESET
V
ALUES
E
NTRY
Filling related target, coarse lead in and fine lead in values are entered by pressing <
> key
shortly
.
The functionality is shown in the diagram below.
Follow the table below to insert the values
.
Display
Operation
[
123.456
kg ]
Press
key
shortly
to enter the menu. [
tArGEt
] prompt will
appear..
[
tArGEt
] [XXXXX ]
Filling Target Entry
Target prompt and its value are toggled on the display.
Enter target value by pressing
and
keys.
Press the
key to go to the next parameter.
[
CoArSE]
] [XXXXX ]
Preset Values ( Cut-off ) Entry
Coarse prompt and its value are toggled on the display.
Coarse lead in = Target
– Coarse cut-off
Enter coarse value by pressing
and
keys.
Press the
key to go to the next parameter.
[
FinE
] [XXXXX ]
Fine prompt and its value are toggled on the display.
Fine lead in = Target
– Fine cut-off
(Please look Figure Figure 6.1)
Enter fine value by pressing
and
keys.
Press the
key to go back to the operation.
Warning:
1)
Changing target value does not require changing the coarse lead in and fine lead in values.
2) Coarse and fine values must be entered carefully to start filling.
Course
Fine
Start
Target