Flexim FLUXUS WD, Operating Instruction

Page: 60 / 174

7 Connection
7.1 Transducers
FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
60
7.1.5 Transducer module (SENSPROM)
The transducer module contains important transducer data for the operation of the transmitter with transducers.
If transducers are replaced or added, the sensor module must also be replaced or added.
The sensor module is connected to the terminals of the transmitter, see Fig. 7.7.
• Disconnect the transmitter from the power supply.
• Connect the transducer module to the corresponding terminal, see Fig. 7.7. Terminal X2 is assigned to the transducers
of measuring channel A, terminal X3 to the transducers of measuring channel B.
• Connect the transmitter to the power supply.
• Enter all parameters of the program branch
Parameters
.
• Start the measurement.
Notice!
The serial numbers of the transducer module and the transducer must be identical. A wrong or incorrectly connected
sensor module will lead to incorrect measured values or to a measurement failure.
Fig. 7.7: Sensor module
1 – transducer module (measuring channel A)
2 – transducer module (measuring channel B)
A B
SNAP
DISP
DISP
MODE FAST
MUX
NEXT
Q
ON
Q+ Q-
3x Q
OFF
LAN USB
A+ B- P1+ P2+ P3+ P4+ P5a P6a P7a
S S P1- P2- P3- P4- P5b P6b P7b
X2 X3
X_AV
KL1
1
KL12 KL7
KL8
KL9
KL10
KL4
X_AR X_BV X_BR
T1A T1B S1 T2A T2B T3A T3B S3 T4B T4A
T1a T1b S1 T2a T2b T3a T3b S3 T4b T4a
N(-) PE L(+)
AV AV
S
AGN ARS AR BV BVS BGN BRS BR
1 2