Fisher Scientific Isotemp 178L 120V, User Manual

Page: 41 / 92

Cleaning and disinfection
For details about the cleaning and disinfection of the low temperature
incubator, please refer to
“Cleaning” on page 9-1 .
Installation procedures
Preparing the usable space
Fisher Scientific Peltier Low Temp. Incubators 5-3
Installation or Removal of the Support Rails
Figure 5-3 Support Rail Installation
The embossings at [2] and [5] act as lateral guides for the support rails, while the embossings
at [1] and [6] secure the support rails in place. For the support rails to install correctly the
retaining spring [3] must be facing upwards.
1. Place the support rail [4] on the lower embossing [6] and tilt it upwards against the work
space side wall so that the rail is positioned over the two embossings at [5] and [2].
2. Clamp the retaining spring [3] behind the upper embossing [1].
3. To remove the support rails, pull the retaining spring tab down out of the embossing and
remove the support rail assembly.