Fisher-Rosemount 3095FT, Manual

Page: 36 / 184

Rosemount Model 3095FT HART Flow Transmitter
3-4
5. The electronics housing may be rotated to improve field access to
the two compartments. To rotate the housing less than 90
degrees, release the housing rotation set screw and turn the
housing not more than 90 degrees from the orientation shown in
Figure 2-6. To rotate the housing greater than 90 degrees, follow
steps 1–6 of the disassembly procedure on Page 5-10.
6. Decide which direction the meter should be oriented. Insert the
long meter screws into the two holes on the meter assembly that
coincide with the holes on the circuit board.
7. Attach the meter assembly to the circuit board by threading the
screws into captive threads and attaching the meter assembly to
the meter connector. Tighten the meter screws in the standoffs to
secure the meter assembly and electronic circuit board in place.
The meter screws are designed to be captive screws, so they must
first be tightened past the captive thread within the standoffs and
then tightened again to hold the meter/circuit board assembly to
the housing.
8. Attach the extended cover
Note the following LCD temperature limits:
Operating: –13 to 185 °F (–25 to 85 °C)
Storage: –40 to 185 °F (–40 to 85 °C)
SST MOUNTING
BRACKETS Optional mounting brackets available with the Model 3095FT facilitate
mounting to a panel, wall, or 2-inch pipe. The bracket option for use
with the Coplanar flange is 316 SST with 316 SST bolts. Figure 2-7
shows bracket dimensions and mounting configurations for the SST
mounting bracket option.
Rotating the housing greater than 90 degrees without
performing the disassembly procedure may damage the
Model 3095FT sensor module.
Explosions can cause death or serious injury. Both
transmitter covers must be fully engaged to meet explosion-
proof requirements.