Fisher-Rosemount 3095FT, Manual

Page: 112 / 184

Rosemount Model 3095FT HART Flow Transmitter
5-14
Reassembly Procedure Follow these procedures carefully to ensure proper reassembly:
1. Inspect all cover and housing (non-process-wetted) O-rings and
replace if necessary. Lightly grease with silicone lubricant to
ensure a good seal.
2. Carefully tuck the cable connector completely inside the internal
shroud. To do this, turn the shroud and cable counterclockwise
one rotation to tighten the cable.
3. Lower the electronics housing onto the module, and guide the
internal shroud and cable through the housing and into the
external shroud.
4. Fasten the housing to the module by turning clockwise.
5. Inspect the threaded connections.
6. Tighten the housing rotation set screw.
To prevent damage to the cable connector, watch the cable
and shroud as you attach the housing to the module. Make
sure the cable connector does not slip out of the internal
shroud and begin to rotate with the housing. Reinsert the
cable connector into the shroud if it escapes before the
housing is fully fastened.
Explosions can result in death or serious injury.
The bottom of the electronic housing must be within
1
/
16
-in.
of the sensor module to maintain explosion-proof
requirements.