Fisher-Rosemount 3095FT, Manual

Page: 171 / 184

E-3
Software Error Messages
DATE CHECKING Standard and complete range checks are performed on all date entry
fields. The date range accepted by the User Interface Software is:
January 1, 1970 00:00:00 to December 31, 2035 23:59:59
The following error messages are possible:
ERROR: Date Format is YY/MM/DD (Too many days are entered for the
given month)
ERROR: The entered hours must be between 0 and 23
ERROR: The entered minutes must be between 0 and 59
ERROR: The entered seconds must be between 0 and 59
ERROR: Date Format is YY/MM/DD (Entered month is not valid)
ERROR: The year must be between 1970 and 2035
DATA VIEW SPECIFIC
MESSAGES The following messages are only issued by the Data View logging
subsystem:
ERROR: There is no more data in the log
An end of data condition occurred while reading the log.
Either the log is empty or less data was available than previously
indicated by log seek operations. The latter condition may indicate that
non-sequential sequence numbers exist on the log records.
ERROR: There are no log records within the specified date range
Log seeks to the specified start and end times indicate that the
transmitter does not contain any log records within the requested date
range.
ERROR: Start time must be less than or equal to end time
The Data View subsystem expects the start time to be less than or
equal to the end time. All log data is retrieved from the transmitter and
displayed in time ascending order.
FILE SYSTEM ERRORS
ERROR: This file could not be opened for reading
The specified Model 3095FT configuration file could not be opened.
Possible Causes:
• the pathname you specified does not exist
• the pathname you specified is greater than 200 characters long
• a hardware error has occurred on the target disk(ette)