Fisher-Rosemount 3095FT, Manual

Page: 35 / 184

3-3
Options and Accessories
Installing the Meter For transmitters ordered with the LCD meter, the meter is shipped
installed. Installing the meter on a Model 3095FT transmitter requires
a small instrument screwdriver and the meter kit (PN 3095-0392-
0001).
The meter kit includes:
• one LCD meter assembly
• one extended cover with cover O-ring installed
• two captive screws
• one meter connector.
Use the following steps and Figure 3-1 as references to install the
meter.
1. If the transmitter is installed in a loop, secure the loop and
disconnect power.
2. Remove the transmitter cover opposite the field terminal side.
3. Insert the meter connector into the six-pin socket on the
electronics circuit board (see Figure 3-1).
4. Remove the two circuit board captive screws. To do this, loosen
the screws to release the board, then pull out the screws until
they are stopped by the captive thread inside the circuit board
standoffs. Then continue unscrewing and remove.
NOTE
The meter may be installed in 90-degree increments for easy viewing.
One of the four connectors on the back of the meter assembly must be
positioned to accept the meter connector.
Explosions can cause death or serious injury. Do not
remove the instrument cover in explosive atmospheres
when the circuit is alive.
The circuit board is electrostatically sensitive. Be sure to
observe handling precautions for static-sensitive
components.