Fisher-Rosemount 3095FT, Manual

Page: 169 / 184

Appendix
E-1
E Software Error Messages
This appendix identifies errors messages that might occur while using
the Model 3095FT User Interface Software.
COMMON ERROR
MESSAGES ERROR: The following data has not yet been entered:________.
The data item described by the message is missing. Enter the data
using the “Configuration” menu.
ERROR: There is no transmitter configuration to send
You attempted to send a configuration to the transmitter but there was
no current configuration. Receive a configuration from the transmitter
or read a configuration file before attempting to send.
ERROR: The connected device is not a Model 3095FT
The manufacturer code and transmitter type codes returned by the
multi-drop device do not match those of a Rosemount Model 3095FT.
The User Interface Software will only connect to a Rosemount Model
3095FT.
ERROR: Address must be between 0 and 15 inclusive
You attempted to enter a transmitter address outside of this range in
the Transmitter, Multidrop screen.
ERROR: A Calculation Method must be selected in Flow Parameters
You attempted to configure gas properties but the calculation method
has not yet been defined in the flow parameters configuration.
ERROR: This Calculation Method is not defined yet
You attempted to configure gas properties but the calculation method
has not yet been defined in the flow parameters configuration.
ERROR: Cannot download while transmitter on-line (use
Maintenance/Maint. Mode to change mode)
The Model 3095FT Transmitter must be in maintenance mode before a
new configuration can be downloaded.
ERROR: Password is not recognized - Security Level unchanged
SECURITY ERRORS An invalid security level password was entered for the currently
connected Model 3095FT transmitter. Try again.
If you have forgotten your security level 1 or 2 password, then go to
security level 3 and modify the appropriate lower level password.
If you have forgotten your security level 3 password, then contact
Rosemount.