Fidelity Measurement AFM18, Operation Manual

Page: 32 / 78

31
www.fi-measurement.com
6.9 Percentage Function
21
Follow the below steps to enter Percentage Function: -
a. Refer to 6.3 on how to select the desired weight unit,
b. If a container is used, place it onto the platform and press [TARE] ,
c. If a reference mass (mass value which is considered as 100%) is
available, apply it on platform,
Note: - If reference mass is not available or reference mass value will be
entered through numeric keys, then ignore this step.
d. Press [FUNC] to shift among various functions until Percentage
Function (PErCnt) appears,
e. Press [M+] to enter,
f. Reference mass value can be entered by anyone of the below methods: -
•
By applying the reference mass onto the platform during
abovementioned step c, or
•
In case there is no reference mass applied to platform, the last reference
mass used will be displayed. Press [M+] to confirm, or
•
In case of new reference mass value, enter it through numeric keys and
press [M+] to confirm. After a new reference mass is entered, this
instrument shows 0% to indicate there is no load applied to platform.
g. This instrument is now ready for percentage calculation.
6.9.1 To Quit Percentage Function
22
Refer to 6.7.2 on how to quit and back to weighing function.
6.10 Animal Weighing Function
23 24 25
Follow the below steps to enter Animal Weighing Function: -
a. Refer to 6.3 on how to select the desired weight unit,
b. If a container is used, place it onto the platform and press [TARE] ,
c. Press [FUNC] to shift among various functions until Animal Weighing
21
Percentage Function does not support memory accumulation (M+) function.
22
After quit, the average piece weight stored will be erased.
23
To enable animal weighing function, set F11 = ON.
24
Weight reading of Animal weighing function cannot be accumulated.
25
Animal Weighing function will not operate when weight is less than 20d (or 20d1 for dual
range).