2. MPA pneumatic modules
2−8
Festo P.BE−CPX−EA−E N en 0705f
Please note
Handle all modules and components of the CPX terminal
with great care. Please note especially the following:
·
Screws must be fitted accurately (otherwise threads will
be damaged).
Screws must be fastened at first only by hand. Place the
screws so that the self−cutting threads are used.
·
The specified torques must be observed.
·
Screw connections must be fitted free of offset and
mechanical tension.
·
Check the seals for damage (IP65).
·
Connecting surfaces must be clean (to ensure sealing
effect, avoid leakage and contact faults).
Dismantling the electronic module
1. Use a screwdriver with a narrow blade to loosen the
fastening screws of all valve or blanking plates and
remove the plates from the sub−bases.
2. Loosen the screws with which the electronic module is
fastened to the sub−base.
3. Pull the electronic module upwards out of the body of the
sub−base.
Summary of Contents for VMPA...-FB-EPL Series
