58
Festo — MSE6-E2M — 2022-08d
Parameterisation
1
2
3
4
Fig. 29: Parameterisation of the MSE6-E2M
1
Interface module or network scanner/bus
master; the desired parameterisation can
be guaranteed e.g. in the start-up phase or
after fieldbus interruptions.
2
User program in the machine controller;
parameters can be modified during opera-
tion.
3
Network-specific configurators; parameters
can be modified during the commissioning
phase or during troubleshooting.
4
Service interface
9.2
Notes on parameterisation
This documentation describes the module parameters of the energy efficiency module. For a detailed
description of the system parameters, diagnostic memory parameters, data and application principles,
see CPX system description
Time behaviour with parameter changes
Due to calculations that are required in some cases, modified parameters are not valid until they have
been thoroughly checked and saved. After a change of value valid input data will not be available for
up to a maximum 30 ms, depending on the parameter.
