Festo 1971599, Manual

Page: 96 / 150

3. Commissioning
3-6
Festo P.BE-CPX-FVDA-P2-EN en 1209NH English
3.3 Commissioning steps
Detailed information on configuration, programming and
commissioning in combination with the F-Host used can be
found in the documentation of the F-Host manufacturer.
Instructions on configuration and commissioning of the CPX
terminal can be found in the description of the CPX bus node.
1. Integrate the GSDML/GSD file into the configuration soft-
ware of the F-Host ( description of the CPX bus node).
2. Configure and parameterise the output module with the
configuration software of the F-Host.
– Add CPX terminal to the configuration ( description
of the corresponding CPX bus node)
– Add output module to the CPX configuration
– Set start address of the inputs and outputs
– Set PROFIsafe parameter of the output module
(
section 3.4)
– If necessary, set standard parameters of the output
module (
section 3.5 and 3.5.1)
3. Create and load the safety program.
4. Commission the CPX terminal on the fieldbus (PROFIBUS
or PROFINET IO) and test the characteristics in trial mode.