Festo 1971599, Manual

Page: 105 / 150

3. Commissioning
3-15
Festo P.BE-CPX-FVDA-P2-EN en 1209NH English
The following image shows an example of the representations
for the output module CPX-FVDA-P2.
Observe that the menus [Forcing], [Fail safe] and [Idle mode]
are not supported for the output module CPX-FVDA-P2.
4
3
2
1
<-
3: FVDO-P2 :M
->
Process State
Valve CH 0
Ext. CH 1 CH 2
Back <->
<-
3: FVDO-P2
->
Monitoring (M)
Diagnostics (D)
Parameters (P)
Module data (MD)
Back OK
<-
3: FVDO-P2 :D
->
No error detected
Back <->
<-
3: FVDO-P2 :P
->
Monitor Vout/Vval: Active
General diagnosis
. Channel 0: Active
. Channel 1: Inactive
. Channel 2: Active
. Module: Active
. Failsafe protocol: Active
Monitor wire fracture
. Channel 0: Active
. Channel 1: Active
. Channel 2: Active
Back <-> Edit
<-
3: FVDO-P2 :MD
->
Output Module Safety
Type code:
193/8
Revision: xxx
Serial No.: 0xAA55CC33
PROFIsafe Addr: 0x2AA
10 1010 1010
Back <->
1
Monitoring (M)
2
Diagnostics (D)
3
Parameters (P) – basic representation
4
Module data (MD)
Fig. 3/2: Special representations for CPX-FVDA-P2 on the operator unit
When the command [Monitoring/Forcing (M)] is called up, the
statuses of the 3 output channels are displayed.