Festo 1971599, Manual

Page: 89 / 150

2. Installation
2-15
Festo P.BE-CPX-FVDA-P2-EN en 1209NH English
2.5.2 Mounting the electronics module
Note
•
Handle the components with care.
•
Make sure that the metal interlinking block is clean and
free from foreign matter, especially in the area of the
contact rails.
•
Check seals for damage.
•
Ensure clean connecting surfaces to optimise the sealing
effect and avoid contact errors.
Note
•
Use only screws with metric threads for the metal
interlinking block CPX-M-GE-EV-FVO.
•
Set screws exactly to avoid damage to thread.
•
Tighten the screws only by hand with a screwdriver.
•
In the threaded connector, avoid any distortion and
mechanical stresses.
•
Comply with the specified tightening torques.
•
Also observe the mounting instructions in the package
insert supplied with modules and components sub-
sequently ordered.
•
Before mounting, make sure that the PROFIsafe address
is correctly set at the electronics module (
section 2.4).
To mount the electronics module and connection block
(
Fig. 1/2 in section 1.1.1):
1. Switch off the operating and supply voltage.