![background image](http://html.mh-extra.com/html/federal-signal-corporation/leach-2r-iii/leach-2r-iii_service-manual_548517048.webp)
SECTION
4
4-2
GENERAL REPAIR PRACTICES
SAFETY PRECAUTIONS
PRIOR TO PERFORMING ANY SERVICE
OR REPAIR
Set the parking brake.
Put the vehical in park, or if equipped with a manual
transmission, put the unit in gear and remove the
ignition key.
Place an OSHA approved chock block in front and
behind the front tire.
If steel supports are to be used to support the tail-
gate, place them as shown in Section 9, SERVICE
AND REPAIR, under TAILGATE REPAIR.
When working on the unit always use the service
tools listed in Section 10, SERVICE TOOLS if so
directed by the instructions in Section 9, SERVICE
AND REPAIR.
Whenever dismantling any hydraulic line, valve, or
cylinder be sure to turn off the hydraulic fluid flow,
relieve the pressure and slowly crack or loosen the
fittings.
1.
2.
3.
4.
5.
6.
SAFETY DURING SERVICE AND REPAIR
Always wear safety glasses.
Disengage the PTO, turn off the ignition and re-
move the keys before:
a. Leaving the truck cab.
b. Examination or lubrication of the PTO,
pump or drive shafts.
c. Entering the front of the body.
d. Entering the tailgate.
Always check to make sure the body access door
is locked shut before entering the cab.
Pump removal; due to the weight and location of
the pump, it is advisable to place a floor jack be-
neath the pump and apply a slight pressure, so that
when the bolts are removed the pump is supported.
When it becomes necessary to raise the tailgate
for maintenance or repair, do not enter the area
beneath the tailgate unless the proper bracing has
first been applied. All bracing and supports must
be able to support 8,000 lbs (3629 kg).
Never enter the body when the load is under com-
paction pressure. Bring the packer panel to the “in-
terrupted cycle” stop position and retract the
pushout panel slightly.
1.
2.
3.
4.
5.
6.
WELDING PRECAUTIONS
ELECTRIC WELDERS
Electric arc welders should have a seperate, fused
disconnect circuit.
Welders must be used according to the manufac-
turers specifications.
All electric welding should be done in a well-venti-
lated area.
1.
2.
3.
The radiation given off by the arc will destroy the
retina of the eye. Wear an approved welder’s hel-
met.
Welding radiation will produce severe burns on un-
protected skin, similar to sunburn, so wear heavy
clothing. Use natural fiber or leather - avoid syn-
thetic fiber clothing.
4.
5.
Summary of Contents for LEACH 2R-III
