![background image](http://html.mh-extra.com/html/federal-signal-corporation/leach-2r-iii/leach-2r-iii_service-manual_548517047.webp)
SECTION 4
4-1
GENERAL REPAIR PRACTICES
!
WARNING
Proper service and repair is important for the safe,
reliable operation of all mechanical products, The
service procedures recommended and described
in this service manual are effective methods for
performing service operations. Some of these ser-
vice operations require the use of tools specially
designed for the purpose. These special tools
should be used when and as recommended. Since
Leach Company could not possibly know, evaluate
and advise the service trade of all possible ways in
which service might be done or of the possible haz-
ardous consequences of each way, we have not ac-
cordingly, anyone who uses a service procedure or
tool
which is not recommended by Leach Company
must first thoroughly satisfy himself that neither
his nor the operator’s safety will be jeopardized by
the service methods selected. Any person who
modifies their equipment must do so in accordance
with American National Standards Institute Z245.1-
1999. It is important to note that deviating from these
procedures could cause damage to the unit or ren-
der it unsafe. However, please remember that these
procedures are not all inclusive.
PREPARATION FOR SERVICE
Proper preparation is very important for efficient safe
service work. A clean work area at the start of each job
will allow you to perform the repair as easily and quickly
as possible and reduce the incidence of misplaced tools
and parts. If the portion of the unit to be repaired is
excessively dirty, it should be cleaned before work starts.
The cleaning process may include the use of high pres-
sure equipment and strong chemicals. Follow the
manufacturer’s instructions and precautions during this
process. Cleaning will occasionally uncover trouble
sources. Tools, instruments and parts needed for the
job should be gathered before work is started. Inter-
rupting a job to locate tools or parts is a needless delay.
Special tools required for a specific job are listed in Sec-
tion 11.
REPLACEMENT PARTS
Of growing concern to the Leach Company is the use
of counterfeit, will-fit or substitute parts. FS Depot re-
placement parts are designed and manufactured to
exacting standards. The use of counterfeit, will-fit or sub-
stitute parts may effect the operation and performance
of the unit and will void the warranty. Insure maximum
reliability and protect your investment- insist on FS De-
pot original factory replacement parts.
TECHNICAL SERVICE BULLETINS
In addition to the information provided in this Service
Manual, TechnicalService Bulletins are issued when
needed to cover interim changes or to provide supple-
mentary information necessary for maintaining the
refuse unit in a proper safe operating condition. (Check
with your authorized Leach distributor.)
A Subsidiary of Federal Signal Corporation
Summary of Contents for LEACH 2R-III
