IL3 User’s Guide
11S-3002B
page 7
2 IL3 Getting Started
2-1 Unpacking the Camera
Part
STD OPT Part #
IL3 Camera
X
IL3100XXX
C-Mount (factory installed and adjusted on the camera)
X
1105-0026
F-Mount (factory installed and adjusted on the camera)
X
1105-0200
PL-Mount (factory installed and adjusted on the camera)
X
1105-0115
DC Power Supply-- 110/220VAC, 50/60Hz, 12V @ 4.17A, with IEC 13 socket and 5-pin
LEMO connector (no power cord included)
X
1105-0250
8 GB SDHC Card
X
1105-0260
16 GB SDHC Card
X
1105-0261
32 GB SDHC Card
X
1105-0262
I/O Cable--1.3 meter with 8-pin LEMO camera connector and BNC connectors for Sync-In,
Sync-Out, and Trigger-In
X
1105-0401
I/O Cable--1.3 meter with 8-pin LEMO camera connector and BNC connectors for Sync-In,
Sync-Out, and Trigger-In
X
1105-0405
Wireless Dongle
X
1105-0275
Documentation and Software (on USB thumb drive)
X
Fastec Imaging retails its cameras through independent distributors. Fastec or its distributors can
provide the accessory items required for camera operation according to each customer’s particular
application needs.
2-2 Installing the Lens
The camera is shipped with a C-mount lens adaptor installed and adjusted at the factory. To install a
C-mount lens, follow these steps:
1. Select a C-mount lens for use with the camera.
NOTE: There are many C-mount lens formats and focal lengths available. The 22.9mm diagonal sensor
of the IL3100S is larger than the light circle produced by many C-mount lenses. This is especially true
for wide angle lenses, but it is dependent on lens design and format. Vignetting (darkening at the
corners or edges of the image), will occur when the image on the sensor, the size and location of
which is dependent on resolution and image offset, is not covered by the image circle of the lens. (See
“Table 2-2: Lens Selection”.)
2. Remove the lens receptacle cover from the camera’s C-mount. This is a cover that is installed at
the factory to protect the camera optics and sensor from dust contamination.
NOTE: Whenever threading lenses on or off the camera, face the camera lens down so that any
contamination on the threads will tend to fall away from the camera rather than into it.
3. Thread the C-mount lens into the lens mount located in the front of the camera. DO NOT over-
tighten the lens! The lens should be “finger tight” only--just tight enough that you can adjust
focus and aperture without unscrewing the lens.
NOTE: Limit the time between removal of the receptacle cover and installation of the lens. Dust could
settle on the face of the sensor cover glass and degrade the image quality.
Table 2-1: Package Contents: