Auxiliary modules
4.
AUXILIARY MODULES
Exte
rnal Brakin
g Resistors
174
Ref.2003
· 148 ·
QC-PDS
HARDWARE
4.3.3
Ohm value
The user will select the required resistor model to be installed according
to table
and depending on the energy to be dissipated in the
application. FAGOR supplies the resistor upon request.
Therefore, use the attached table to select the resistor for your QC-PS-
module with enough rms dissipation power to dissipate the energy
generated while braking.
Installation
See section,
8.5.6 CONNECTING THE EXTERNAL BRAKING RESISTOR(S) TO NON-
Chapter
of this manual shows the dimensions.
WARNING.
When connecting an external Ballast resistor, make sure that
its Ohm value is exactly the same as the one shown in the technical
characteristics table for the corresponding non-regenerative power supply
in chapter
of this manual.
T. H4/10
Selecting the Ballast resistor according to the installed non-
regenerative power supply. Required Ohm values.
POWER SUPPLY
OHM
RMS POWER
RESISTANCE
QC-PS-025
QC-PS-045
18
950 W
ER-TH-18/1100
1.3 kW
ER-TH-18/1800
2.0 kW
ER-TH-18/2200
2.0 kW
ER-TH-18/1000+FAN
3.0 kW
ER-TH-18/1500+FAN
4.0 kW
ER-TH-18/2000+FAN
Summary of Contents for QC-PDS
