Fagor QC-PDS, Hardware Manual

Page: 173 / 420

  
Auxiliary modules
AUXILIARY MODULES
Bu
s P
rot
ec
tion
M
o
du
le
4.
Ref.2003
· 173 ·
QC-PDS
HARDWARE
A18 connector.
+24 V DC input
Male 2-pin connector located behind the bottom cover of the unit and
identified as A18.
Female aerial plug connector with clamping yoke supplied as an
accessory. It is used to 24 V DC (provided by the auxiliary power
supply) to the control electronics of the unit connected to the DC BUS.
The following table shows the main data of the aerial connector and the
wire to be connected:
Pinout
Pin description
Installation
Connector data
Nr of poles 2 / 90°|270°
Gap (mm) 5.08
Min./max. tightening torque (N·m) 0.4/0.5
Flat screwdriver, size (mm) 0.6 x 3.5
Min./max. allowed cross-section (mm²) 0.2/2.5
Current (A) < 15
Connection data
Length to strip (mm) 7
Wire section (mm²) 2.5
F. H4/27
A18 connector. Pinout.
T. H4/18
A18 connector. Pin description.
Pin Signal Description
+24V
+24 V DC
+24 V DC voltage input
GND
0 V DC
Reference 0 V DC
F. H4/28
A18 connector. +24 V DC connections for the QC-BPM-100.
+24V
GND
+24V
GND
+24V
GND
A18
QC-APS3-15
QC-RPS-030-FF2 QC-DR-40-FS2
QC-DR-30+30-FD2
QC-BPM-100