Fagor CNC 8055, Operating Manual

Page: 203 / 256

Operating manual
CNC 8055
CNC 8055i
GRAPHIC EDITOR
11.
·T· M
ODEL
S
OFT
: V02.2
X
·203·
Editin
g u
s
er scree
ns
(p
age
s)
an
d symbo
ls
One of the color rectangles shown has another rectangle in it. The inside rectangle indicates the
selected main color and the outside rectangle indicates the selected background color.
To select the background color, proceed as follows:
1. Use the [

] [

] [

] [

] keys to select the desired background color among the 16 shown on
the screen.
The CNC will show with the inside rectangle the currently selected background color.
2. Press [ENTER] to validate the selected color or [ESC] to quit this mode leaving the previous
selection intact.
When editing a new page or symbol, the CNC assumes a blue background color by default.
"MAIN COLOR" softkey
With this option it is possible to select the color used to draw and write texts on the page (screen)
or symbol.
One of the color rectangles shown has another rectangle in it. The inside rectangle indicates the
selected main color and the outside rectangle indicates the selected background color.
To select the main color, follow these steps:
1. Use the [

] [

] [

] [

] keys to select the desired main color among the 16 shown on the screen.
The CNC will show the main color being selected by placing a white inside rectangle. It will also
display the rectangle containing both the selected background color and the main color being
selected here.
2. Press [ENTER] to validate the selected color or [ESC] to quit this mode leaving the previous
selection intact.
When editing a new page or symbol, the CNC assumes white as the main color by default.
"GRID" softkey
This option displays a grid of points with a 16-pixel pitch on the screen.
The grid points will be white when the selected background color corresponds to one of the 8 upper
color rectangles and they will be black when the selected background color corresponds to one of
the 8 lower color rectangles.
Press this softkey again to get rid of the grid.
Every time the grid is displayed, the CNC will reset the cursor step to 16 pixels.
Since this value coincides with the distance between grid points, the cursor will move from point to
point on grid However, the cursor advance may be modified afterwards by selecting it with the
CURSOR ADVANCE softkey.