Factory Five Racing Mk3 Roadster, Assembly Manual

Page: 95 / 277

95
www.factoryfive.com 508-291-3443
1.
Push the harness plugs through the hole in the driver's side floor aluminum.
Harness plug in floor aluminum
2.
Run the harness forward into the corner to the ¾” tube at the foot box front. Then go up and along the
angled ¾” tube to its connector. Make sure that it does not get in the way of the accelerator pedal.
Use the drilled holes and the zip tie trick to keep the harness in the corner along the floor.
Headlight Harness
Headlight harness section.
1. The headlight harness is started at the alternator and runs forward to the passenger headlight area, then
goes under the fan shroud to the driver’s side headlight area and then rearward to the coil and starter
relay area.
2. The Mustang is wider than the FFR Roadster in front and there is extra wiring between the headlights.
3. By removing the tape from the harness under the radiator, overlapping the wires, re-taping and using
the loom material provided, a cleaner looking harness can be made.
4. Attach the harness to the channel on the bottom of the radiator using zip ties.
5. If using a 94-95 harness and computer, connect the electric fan to the stock factory fan connector.
The fan will be controlled by the computer.