Factory Five Racing Mk3 Roadster, Assembly Manual

Page: 119 / 277

119
www.factoryfive.com 508-291-3443
Side louver cut out
.
Headlight Cut-Outs
TOOLS: Hand jigsaw, drill, marker, tape,
7
/
16
” drill bit.
1.
Using a
7
/
16
” drill bit, drill the two holes marked at the headlight mount locations.
2. On the headlight template that follows, cut out the two small holes and the inner solid line circle.
Leave the template attached to the paper so that it has extra support.
3. Tape the template to one of the headlight locations.
4. Draw around the inner circle with a marker.
5. Drill a
7
/
16
” hole in the inside of the circle so that the edge of the hole is just touching the circle.
6. Use a jigsaw to cut the circle out.
Headlight and turn signals cut out.