Factory Five Racing Mk3 Roadster, Assembly Manual

Page: 118 / 277

118
www.factoryfive.com 508-291-3443
Driver's side exhaust cut out
Turn Signal and Tail Light Cut-Outs
TOOLS: 1.25”holesaw,
3
/
16
” drill bit, drill.
1.
Use a 1.25” hole saw at the turn signal mount location to make the center hole.
2. Use the rubber gasket as a template to mark the locations of the smaller holes.
3. Use a drill and a
7
/
32
” bit for the small holes.
4. Test fit the lights. You may have to bend the ground tab slightly or file away a bit at the hole to make
it fit perfectly.
5. Use a 1.25” hole saw at the Tail light mount location to make the center hole.
6. Cut out the template in Appendix A using the center holes to position the template on the body.
7. Drill the Tail light small hole locations using a
3
/
16
” drill bit.
8. Test fit the lights. You may have to bend the ground tab slightly or file away a bit at the hole to make
it fit perfectly.
Side Louver Cut-Outs
TOOLS: Hand jigsaw, ⅞ ”, 1.25” hole saw.
1.
At the corners of the louver indentation, use a 1.25” hole-saw for the larger angle and a
7
/
8
” hole saw
for the smaller angle.
2. The hole-saws will fit in the louver lip.
3. Use a jigsaw or hacksaw for the straight edges.