Factory Five Racing Mk3 Roadster, Assembly Manual

Page: 72 / 277

72
www.factoryfive.com 508-291-3443
3. Run the line up along the backside of the 2”x 3” frame members and across to the ¾” tubing that runs
down forward to the transmission rear mount.
4. Attach the line to the frame with the small size insulated line clips (FFR# 10970) and
3
/
16
” rivets
provided with your kit.
5. Drill two holes for the Mustang brake bracket on the underside of the 2”x 3” frame member and
mount the Mustang bracket.
Rear end brake line mount next to the ¾” tubing
.
6. Attach the brake line to the Mustang mount.
Front Brake Line
1.
Hold the front flexible line to the frame just behind the upper A-arm on the ¾” tubing in the opening.
Rotate the front wheels to check for wheel clearance. Move the brake line mount around if necessary
or bend the hard line attached to the caliper slightly so that when the wheel is turned all the way, the
line is not stretched too tight.
2. Attach the front flexible brake line to frame.
3. Use the Mustang clip to attach the flexible line.
4. From the bottom of the master cylinder, run the 20” brake line forward to the left front brakes.
5. Using the distribution block diagram below, attach the other 60” brake line to the distribution block.
Brake Line Routing at Distribution Block