C4000I
37
532100 - Rev.A
Tr
ansla
tion of the original instruc
tions
ENGLISH
learning phase has started.
3. Release the button; the E4000I now remains in
the learning phase for approximately 20 seconds.
4. Make sure that the LED DL4 or DL5 on the board
is still flashing and press the button of the DS
radio control that you wish to memorise for a few
seconds. The corresponding LED (DL4 or DL5)
on the board will turn on with a steady light for
1 second and then turn off to indicate that the
procedure was completed successfully.
5. To add different codes, repeat the procedure
starting from point 1.
6. For additional radio controls, use the same ON/OFF
combination as the 12 DIP switches on the radio
control that has been memorised.
DELETING RADIO CONTROLS FROM MEMORY
!
This procedure cannot be reversed. It will delete ALL
radio control codes that have been memorised as
OPEN A and OPEN B/CLOSE. The deletion procedure is
only active in the gate status display mode.
1. Press and hold down the
-
button.
-
-
After pressing the button for about 5 seconds, LED
DL5 starts to flash slowly. After another 5 seconds
of slow flashing and holding the button down, the
LEDs DL4 and DL5 will start to flash more quickly
(deletion started).
-
Once the quick flashing stops, the LEDs DL4 and
DL5 will turn on with a steady light to confirm that
all the radio codes (OPEN A and OPEN B/CLOSE)
have been deleted from the board’s memory.
2. Release the - button. The LEDs turn
off, indicating that the codes were
deleted correctly.
-
