4 Remove the module from the antistatic packaging as follows:
a Place the antistatic bag containing the module on a flat ESD-protective surface that is clear of
any debris.
b Break the quality seal, the ESD warning seal, and the Read Installation Note seal.
c Open the antistatic bag and firmly grasp the rail of the module.
d Hold the rail of the module as you pull the antistatic bag off the module.
Note
By holding the rail of the module and pulling the ESD bag off the module, you prevent
damage to the module that might be caused by sliding the module on the ESD surface.
Store the module packaging for future use.
Caution
To prevent ESD damage, hold the module by the metal rail and front panel only. Never
touch the components on the PCB or the pins on any of the connectors.
5 Verify that the module injector/ejector handles are open (
see the following figure
).
Figure 64: Injector/ejector Handles in an Open Position
6 Keep the injector/ejector handles in the open position as you slide the module into the chassis slot.
Caution
Do not slide the module into the open chassis slot if the injector/ejector handles are in the
latched position.
Installing Modules and Establishing Initial Management Access
BlackDiamond 8800 Hardware Install Guide
91
