The power supply bay in the BlackDiamond 8800 Series switch can accommodate up to six hot-
swappable AC power supplies.
Note
In a BlackDiamond 8806 system, the 700/1200 W AC power supply can be combined with a
600/900 W AC power supply in the same chassis.
We do not recommended using the 700/1200 W AC power supply with a 1200 W DC power
supply in the same BlackDiamond 8800 Series switch.
Required Tools and Equipment
You need the following tools and equipment to install or remove an Extreme Networks AC power
supply:
•
Thermal protective gloves (required for removal)
•
Power supply cord (110 V AC, 220 V AC, or applicable to country of use)
An AC power cord is not included with Extreme Networks AC power supplies. You must obtain a
power cord that meets the requirements in
Cable Routing for PoE Devices
on page 143. See the
input specifications in
Table 37: Specifications for the AC PS Model # 41050 (600/900 W AC PSU)
on page 159.
Installing the Power Supply
Caution
Make sure that the AC power supply circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions.
To install an Extreme Networks AC power supply:
1 Verify that the power supply is right side up and the locking handle is open (
see the following
figure
).
Figure 55: Extreme Networks AC Power Supply with Locking Handle Open
Installing Power Supply Units (PSUs)
BlackDiamond 8800 Hardware Install Guide
80
