5 At the edge of the module, rotate the hot-swap prevention latch up and hold it out of the way. Slide
the card the rest of the way into the slot (
see the following figure
).
Figure 78: Inserting the Port Option Card
6 Release the hot-swap prevention latch and verify that the card has engaged the alignment pins and
connector at the back of the card.
7 At the back of the card, align and finger-tighten the captive retaining screws to secure the card in
place (
see the following figure
).
Figure 79: Securing the Port Option Card
8 Re-install the MSM, following the instructions in
Installing a BlackDiamond 8000 Series Module
on
page 90.
Leave the ESD-preventive wrist strap permanently connected to the switch so that it is always available
when you need to touch ESD-sensitive components.
Removing a Port Option Card
To remove a port option card from an 8500-MSM24, 8800-MSM48c, 8800-MSM96, or 8900-MSM128
module:
Installing BlackDiamond 8800 Series Module Options
BlackDiamond 8800 Hardware Install Guide
107
