Setting Up Copper Tests
MaxTester Copper Test
65
Application Settings
Standard
The
Standard
tab allows you to set unit parameter
values composed of the following:
Standard Selection
Standard
allows you to specify if the copper tests
should conform to the
ITU
(International
Telecommunications) or
ANSI
(American National
Standards Institute) standard.
Note:
Selecting the
Standard
resets the default
Measurement Units
,
Label Customization
, and
Test
Parameters Preset
for the page.
Measurement Units
Distance
lists the measurement units for distance in feet or meters.
Temperature
lists the measurement units for temperature in
F
(Fahrenheit) or
C
(Celsius).
Level
lists the units of power level in dBm or dBRN.
Capacitance
lists the units of capacitance for Tip and Ring in
(nF/km
or
nF/mi)
.
Resistance
lists the units for resistance in
(
Ω
/km
or
Ω
/mi)
.
Attenuation
lists the units for the reduction in signal strength or
insertion loss of the cable, in
(dB/km
or
dB/mi)
.
Power Spectral Density
(PSD) lists the units to measure the noise
energy at a point in a noise spectrum. Units are dependent on the
previously selected
Level
.
