EXFO FTB-860, User Manual

Page: 170 / 409

Ping Test Setup and Results
158
FTB-860/880
Global Configuration
IP

Source IP Address : Displays the Source IP Address configured in the
Network
page. To modify the
Source IP Address,
press
IP Config
. For
more details, see Source IP Configuration Pop-Up on page 309.
Note:
For IPv6, instead of Source IP Address , configure Source Link Local IPv6
Address and Source Global IPv6 Address .

Destination IP Address:
Enter the
Destination IP Address
of the
network device to be detected.
The default setting for IPv4 is
10.10.0.0
or is set automatically to the IP
address of the target module from the Remote Loopback mode. The
destination IP address is configured only when
Ethernet/IPv4/UDP
is
selected. The accepted range for IPv4 is 0.0.0.0 to 255.255.255.255 .
The default value is
0.0.0.0
.
The default setting for IPv6 is
2001:0000:0000:0000:0000:0000:0000:0000
or is set automatically to
the IP address of the target module from the Remote Loopback mode.
The destination IP address is configured only when
Ethernet/IPv6/UDP
is selected. The IPv6 Address can either be the Link-Local IPv6
Address
or the
Global IPv6 Address
. The acceptable range for IPv6 is
from 000:0000:0000:0000:0000:0000:0000:0001 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
.

Data Size (Bytes) : Enter the buffer size that will be sent to the network
device to be detected. Choices are
0
to
1452 bytes
. Default value is
32 bytes .

TTL
for IPv4 and
Hop Limit (TTL)
for IPv6: Enter the maximum
number of hops the packet can go through. Choices are 1 to 255 . The
default setting is
128
.

IP TOS/DS for IPv4 and Traffic Class (TOS/DS) for IPv6: Enter the type
of service. Choices are
00
to
FF
. The default setting is
00
.