49
Xe
sar
Sy
st
em
manu
al
2
.0
f
or
v
er
si
on
2
.0
.3
6.1
7
| 2
4.
06
.2
01
5
| mi
spr
int
ing
and
te
chni
cal
c
hange
s
re
se
rv
ed
Battery replacement procedure
1.
The battery compartment is located in the outside handle of the Xesar handle. You require
one type CR123A battery (please ask you retailer for a list of recommended battery mod-
els) and the following tools to open the battery compartment: Allen key, 2.5.
2.
If you would like to remove the handle tube of the outside handle, use the Allen key and
turn the attachment screw anti-clockwise until you can remove the handle tube.
3.
Make sure you only screw in the attachment screw as far as absolutely necessary.
4.
Now remove the empty battery and replace it with a new battery you acquired earlier. En-
sure correct polarity when inserting the battery.
5.
Once again position the handle tube on the outside handle and fasten it in reverse se-
quence.
The component outputs a signal to confirm having correctly completed the battery replacement
(signal 8 in the signal table from Section
Battery replacements or power cuts must not exceed a duration of one minute as
otherwise the Xesar handle must be resynchronised using the Xesar tablet.
Summary of Contents for Xesar 2.0
Page 1: ......
