59
Xe
sar
Sy
st
em
manu
al
2
.0
f
or
v
er
si
on
2
.0
.3
6.1
7
| 2
4.
06
.2
01
5
| mi
spr
int
ing
and
te
chni
cal
c
hange
s
re
se
rv
ed
Please proceed as described in the assembly manual to replace batteries in your Xesar cylinder,
only in reverse order.
1.
Completely position the cylinder tool on the dedicated recess on the rear of the outside
thumbturn and turn the thumbturn and the tool in anti-clockwise direction.
2.
Now remove the cylinder tool and undo the three attachment screws on the rear of the
outside thumbturn using a Phillips screwdriver (PH1). Subsequently remove the thumbturn
disc.
3.
Carefully open the lock in the outside thumbturn by initially moving it carefully before un-
folding it.
4.
Now remove both empty CR2 batteries and clean the battery contacts using a soft, lint-
free cloth.
5.
Now insert the two new and previously acquired batteries with the correct polarity into the
battery compartment and close it once again.
6.
Battery replacements must not take longer than one minute. Resynchronising using the
Xesar tablet may be required once this period has expired.
7.
Once you have correctly replaced the batteries, the component initialises and the corre-
sponding acoustic signal sounds (signal 8 in the signal table in Section
8.
Now once again position the thumbturn disc and fasten it using the three screws.
9.
Completely position the cylinder tool on the rear of the outside thumbturn and fasten
both components to the cylinder together (in clockwise direction) until you can feel re-
sistance. Subsequently turn the cylinder in the opposite direction (anti-clockwise) until you
hear a click.
10.
You can now once again remove the cylinder tool.
Summary of Contents for Xesar 2.0
Page 1: ......
