01-2019 5505 00
35
bDv
i
mmEDiatE
cHaNgE
The amount relative to a selection is gener-
ally cashed after the machine has sent the
“Successful selection” signal.
If you enable this function, which is disa-
bled by default, the cash signal is sent at
the start of the dispensing cycle.
The setup of this parameter is compulsory.
b
ookiNg
timE
To set up for the cash payment how long
the machine displays the residual credit
necessary to dispense the selection (7 sec-
onds by default).
t
ypE
of
DispENsiNg
.
Used to set the operation mode by multiple
or single dispensing. In case of multiple
dispensing, the change is not automatically
given at the end of a successful delivery,
but the credit will remain available for fur-
ther dispensing. If you press the coin return
button, the remaining credit will be returned
if its value is lower than the maximum
change value.
c
rEDit
rEturN
(
Escrow
lEvEr
)
Used to enable/disable the credit return (by
pressing the change return key) if no dis-
pensing has been performed.
If enabled, this function will provide for the
return of the coins even if the first dispens-
ing cycle has not occurred.
If a delivery has failed for any reason what-
soever, the change will be dispensed.
m
aximum
crEDit
Function used to define the maximum ac-
cepted credit for inserted coins.
m
aximum
cHaNgE
You can set a limit on the total amount of
the change the coin mechanism will pay
as soon as you press the change button or
after one single dispensing.
The credit exceeding the amount you
have programmed by this function will be
cashed.
c
oiNs
accEptED
Used to define which coins shall be ac-
cepted among those recognised by the
validator.
For the coin/value correspondence check
the label showing the position of the coins
on the coin mechanism.
c
HaNgE
coiNs
accEptED
Used to program the refusal of a coin in
case of “exact amount”.
For the coin/value correspondence check
the label showing the position of the coins
on the coin mechanism.
E
xact
cHaNgE
EquatioN
Used to define the combination of empty
tubes intended to set the coin mechanism
to the “exact amount” mode. All possible
combinations of empty tubes are listed
here below.
For reasons of simplicity, the combination
is described with reference to tubes A, B
and C, where tube A will receive the lowest-
value coins and tube C the highest-value
coins.
0
=
A or (B and C)
1
=
A and B and C
2
=
A and B only
3
=
A and (B or C)
4
=
A only
5
=
A or B only (default)
6
=
A or B or C
7
=
A or B only
8
=
A or C only
9
=
B and C only
10 =
B only
11 =
B or C only
12 =
C only