01-2019 5505 00
67
CONFIGURATION OF VISIOSHOP
TRAYS
To modify the configuration of the tray, re-
move the tray from the equipment.
The following regulations are possible:
-from a single compartment to a double
compartment and vice versa
-width of compartments (e.g. triple com-
partment)
-horizontal positioning of the spiral motor
-vertical positioning of the spiral motor sup-
plied as a kit (if spirals having a different
diameter are combined on the same tray).
After modifying the configuration of the
tray, configure the displays of the trays
(if any) and make the test selections to
check the correct operation.
DiamEtEr
of
spirals
Every single spiral diameter requires a
specific bracket for fastening motors; the
bracket enables the operator to use spirals
having the same diameter on the whole
tray.
The bracket for fastening motors is inter-
changeable.
Use the special kit to combine spirals hav-
ing a different diameter on the same tray.
from
a
siNglE
compartmENt
to
a
Dou
-
blE
compartmENt
To shift from a single compartment to a
double compartment, act as follows:
1. Remove the tray to be modified.
2. Unhook the compartment wall by acting
on the hook; then lift it to remove it
Fig. 28
