70
01-2019 5505 00
vErtical
motor
positioNiNg
The motor can be regulated vertically
by using the kit to be applied to the tray.
Vertical positioning is necessary if spirals
having a different diameter are used (in
combination) on the same tray.
The kit is provided with assembly instruc-
tions.
To regulate the vertical motor positioning,
act as follows:
1. remove the spirals of the motors, the
vertical position of which you wish to
regulate
2. unhook the motor support
3. unhook the motor from the support and
hook it to the slot according to the size of
the spiral in use.
4. re-place the motor support by hooking it
to the rear wall of the tray
1
2
C
B
A
C
B
A
Fig. 34
1. Motor support (supplied in the kit)
2. Spiral motor
A. motor slot with large spiral (87 mm)
B. motor slot with standard spiral (71 mm)
C. motor slot with small spiral (55 mm)
PRODUCT SPACER
The spacers must be used to load “narrow”
products.
Mount them in such a way that they can
contain the product - without blocking it -
towards the right side of the compartment
so that it stays upright.
Insert the longest part of the bracket into
the hole on the compartment wall.
Couple the shortest part of the bracket with
the spacer in one of the 5 notches. Adjust-
ment notches enable the spacer to pro-
trude more or less from the compartment.
The maximum projection from the com-
partment may be useful for some types of
products.
The spacer remains mobile. Push it for-
wards or backwards to adjust it to the type
of product to be dispensed.
However, leave at least 3 mm between the
spacer and the product.
1
2
3
Fig. 35
1. Product spacer
2. Bracket
3. Regulation notches
